Acelepryn Turf Insecticide

ACELEPRYN Turf Insecticide is an anthranilic diamide insecticide in the form of a suspension

concentrate. ACELEPRYN Turf Insecticide delivers excellent preventative performance, with optimal results achieved with application early in the season (mid September) with the appearance of over-wintering adult pests.

The long residual performance of ACELEPRYN Turf Insecticide will provide up to 6 months protection at the higher application rates. Curative control with ACELEPRYN Turf Insecticide on pest outbreaks later in the season (mid December onwards) can be achieved using the higher recommended application rates.

Formulation/ Analysis:

  • ACELEPRYN Turf Insecticide contains 200 g/L
  • CHLORANTRANILIPROLE in the form of a suspension concentrate.

Potential for Burn: 

When mixing or applying wear protective clothing including, overalls, waterproof gloves and footwear. Avoid contact with skin and eyes and inhalation of spray mist.

Application Timing, Special Instructions and Rates:

    • 750ml to 1.5L rate/ha
    • Fill spray tank to 1⁄4 to 1⁄2 full of water. Measure the amount of ACELEPRYN Turf Insecticide required for the area to be sprayed. Add ACELEPRYN Turf Insecticide directly to the spray tank with the agitation engaged. Mix thoroughly to disperse the insecticide. Once dispersed, the material must be kept in suspension at all times by continuous agitation. Use mechanical or hydraulic means. 
    • DO NOT use air agitation, premix or slurry.If spray solution is left standing, ensure thorough reagitation of the spray mix until fully esuspended. DO NOT allow spray mix to sit overnight, as resuspension may be difficult.
    • Apply extremely coarse droplets using nozzles such as Turbo Floodjet* (TF5) or Turfjet* (TTJ10).
    • Spray with at least 400 L of water/ha to ensure even coverage.
    • The required water volume may be determined by applying different test volumes, using different settings on the sprayer, from industry guidelines or expert advice.
    • Note that the amount of product specified in the Directions for Use table is per hectare of product. You will need to determine your spray rate per hectare before deciding on the amount of product to add to the tank.
    • For optimal control, irrigate with approximately 6 mm of water immediately after application (except where treating for Caterpillars, when irrigation and mowing should be delayed for 24 hours).
    • DO NOT apply when wind speed is less than 3 or more than 20 kilometres per hour at the application site.
    • DO NOT apply when there are aquatic and wetland areas including aquacultural ponds or surface streams and rivers downwind from the application area and within the mandatory no-spray zone of 10 metres.
    • Immediately following application, thoroughly clean all spray equipment to reduce the risk of forming hardened deposits which might become difficult to remove. 

Pack Sizes: NA

For more info please email Stu at stu@greenspaceconsulting.co.nz.